Rendezvous AWD V6-3.6L VIN 7 (2004)
27. Install a new retaining ring to the axle shaft.
28. Position the outer joint horizontally.
29. Engage the inner race splines onto the axle shaft splines.
30. Compress the axle shaft retaining ring.
1. Press the end of the retaining ring, using a flat bladed tool, into the axle shaft groove while firmly pressing the outer joint onto the axle shaft.
2. Continue to work around the retaining ring until it is compressed.
31. Important: The axle shaft and inner race must be fully seated to each other.
Install the outer joint to the axle shaft.
1. Position a wood block squarely over the end of the outer joint threaded shaft.
2. Use a hammer to drive the outer joint onto the shaft.
3. Continue to drive the outer joint until the outer joint seats fully onto the axle shaft.
32. Insert the remaining grease from the service kit into the seal.
