Rendezvous AWD V6-3.6L VIN 7 (2004)
4. Press the flange (1) onto the driven shaft.
5. Notice: Refer to Fastener Notice in Service Precautions.
Install the extension housing assembly to the J 44755 (2) using M8 x 1.25 bolts (1).
Tighten the bolts to 25 Nm (18 ft. lbs.).
6. Install the flange nut (1) onto the driven shaft.
Tighten the flange nut to 250 Nm (185 ft. lbs.).
7. Remove the extension housing assembly from the J 44755.
8. Measure the rotating torque of the driven shaft in both directions.
The driven shaft and bearings should have a rotating torque of 1.5 Nm (13 inch lbs.).
