Rendezvous FWD V6-3.4L VIN E (2005)
7. Disconnect the rear parking assist electrical connector.
8. Remove the rear fascia from the vehicle.
9. Remove the rear parking assist object sensor from the rear bumper fascia. Refer to Rear Object Sensor Replacement in Rear Parking Assist.
10. Remove the energy absorber from the rear fascia.
Installation Procedure
1. Install the energy absorber to the rear fascia.
2. Install the rear parking assist object sensor to the rear bumper fascia. Refer toRear Object Sensor Replacement in Rear Parking Assist.
3. Partially install the rear bumper fascia.
4. Connect the rear parking assist electrical connector.
5. Position the rear bumper fascia to the vehicle.
6. Engage the ball stud on each side of the rear bumper fascia.
