Rendezvous FWD V6-3.4L VIN E (2005)
Hood Shock / Support: Service and Repair
Assist Rod Replacement - Hood
Removal Procedure
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle
or personal injury.
1. Open and support the hood.
2. Lift up the retainer clips on the assist rod using a small flat-bladed tool.
Notice: Refer to Liftgate/Hood Assist Rod Notice in Cautions and Notices.
3. Pull the upper end of the assist rod from the ball joint on the hood.
4. Pull the lower end of the assist rod from the ball joint on the lower hood hinge.
Installation Procedure
1. Press the upper end of the assist rods on to the ball joint on the hood.
