Rendezvous FWD V6-3.4L VIN E (2005)
7. Install the frame to chassis front bolts.
Tighten the bolts to 155 N.m (114 lb ft).
8. Install the frame to chassis rear bolts.
Tighten the bolts to 240 N.m (177 lb ft).
9. Remove the alignment pins from the frame.
10. Install the transaxle mount nuts.
Tighten the nuts to 47 N.m (35 lb ft).
11. Install the engine mount nuts.
Tighten the nuts to 47 N.m (35 lb ft).
12. Remove the utility stand from the powertrain.
13. Use a utility stand to support the frame.
14. Remove the rear frame bolts.
15. Use the utility stand in order to lower the frame and powertrain.
16. Connect the wheel speed sensor wiring harnesses to the lower control arms.
17. Connect the wheel speed sensor harness connectors.
18. Connect the lower control arms to the steering knuckles. Refer to Steering Knuckle Replacement in Front Suspension.
19. Connect the power steering cooler pipe to the pressure hose. Refer to Power Steering Cooler Pipe/Hose Replacement in Power Steering System.
20. Install front fender liner. Refer to Front Fender Liner Replacement (See: Fender/Front Fender/Front Fender Liner/Service and Repair) in Exterior
Trim.
