Rendezvous FWD V6-3.4L VIN E (2005)
6. Notice: Do not use a metal tool for seal removal. Damage to the caliper bore or the seal grooves can result.
Remove the piston seal (4) from the groove in the caliper bore (3). Use a small wooden or plastic tool.
7. Inspect the caliper bore (3) and the seal grooves for the following conditions:
^
Scoring
^
Nicks
^
Corrosion
^
Wear
8. Use a piece of crocus cloth in order to polish out light corrosion.
9. Replace the caliper (3) if corrosion in and around the seal groove cannot be cleaned with a piece of crocus cloth.
10. Inspect and replace any brake caliper bolt boots (4) that exhibit any of the following conditions:
^
Cuts
^
Tears
^
Deterioration
11. Inspect the caliper bolts for corrosion or damage. If corrosion is found on the brake caliper bolt shaft, replace the brake caliper bolt (1) and the
brake caliper bolt boot (4). Do not attempt to polish away the corrosion.
12. Inspect the seal groove in the caliper bore for nicks or burrs. Replace the caliper if the seal groove is damaged.