Rendezvous FWD V6-3.4L VIN E (2005)
Air Door Actuator / Motor: Service and Repair
Air Temperature Actuator
AIR TEMPERATURE ACTUATOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the knee bolster.
2. Set the HVAC controls to the vent mode to position the defroster door lever.
IMPORTANT: The HVAC controls must be set to the vent mode to position the defroster door lever for access to the air temperature actuator.
3. Remove the temperature door lever bolt (3) from the HVAC module.
4. Disconnect and remove the temperature door lever spring (2).
5. Disconnect and remove the temperature door lever (1) from the temperature door.
6. Disconnect the air temperature actuator electrical connector.
7. Remove the air temperature actuator mounting screws.
8. Remove the air temperature actuator.
INSTALLATION PROCEDURE
1. Install the air temperature actuator.
2. Install the air temperature actuator mounting screws.