Rendezvous FWD V6-3.4L VIN E (2005)
Relay Box: Service and Repair
Console Electrical Center or Junction Block Replacement
CONSOLE ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the front floor console.
3. Disconnect the electrical connectors (1,2,3) from the body control module (BCM).
4. Disconnect the electrical connectors (1,2) from the console accessory wiring junction block.
5. Release the retainers (1) from the junction block.
6. Remove the junction block (2) out of the bracket.
7. Remove the BCM.
INSTALLATION PROCEDURE
1. Install the BCM.
2. Install the console accessory wiring junction block (2) into the bracket.
3. Secure the junction block retainers (1).