Rendezvous FWD V6-3.4L VIN E (2005)
1. Lubricate the new O-ring with clean engine oil, then connect the O-ring and the engine fuel return pipe to the fuel pressure regulator.
2. Lubricate the new O-ring with clean engine oil, then connect the O-ring and the engine fuel feed pipe to the fuel rail.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the engine fuel pipe fittings to 17 N.m (13 lb ft).
3. Reinstall the upper intake manifold assembly.
4. Connect the quick-connect fittings in the engine compartment.
5. Tighten the fuel fill cap.
6. Inspect for fuel leaks with the following procedure:
1. Turn ON the ignition for 2 seconds.
2. Turn OFF the ignition for 10 seconds.
3. Turn ON the ignition.
4. Inspect for fuel leaks.