Rendezvous FWD V6-3.4L VIN E (2005)
7. Pressing the J 38125-12A (GM P/N 12094429) tool in the release cavity of the terminal you are removing, gently pull the wire out of the back of
the connector. Always remember never use force when pulling a terminal out of a connector. See the release tool cross reference in the Reference
Guide of the J 38125-D to ensure that the correct release tool is used.
TERMINAL REPAIR PROCEDURE
Use the appropriate terminal and crimper in the J 38125-D in order to replace the terminal.
Repairing Connector Terminals
REPAIRING CONNECTOR TERMINALS
TOOLS REQUIRED
J 38125-D Terminal Repair Kit
Use the following repair procedures in order to repair the following:
-
Push to Seat terminals
-
Pull to Seat terminals
Some terminals do not require all of the steps shown. Skip the steps that do not apply for your terminal repair. The J 38125-D contains further
information.
1. Cut off the terminal between the core and the insulation crimp. Minimize any wire loss.For cable seal terminals, remove the seal.
2. Apply the correct cable seal per gage size of the wire, if used.Slide the seal back along the wire in order to enable insulation removal.
3. Remove the insulation.
4. For sealed terminals only, align the seal with the end of the cable insulation.
5. Position the strip in the terminal.For sealed terminals, position the strip and seal in the terminal.
6. Hand crimp the core wings.
7. Hand crimp the insulation wings.For sealed terminals, hand crimp the insulation wings around the seal and the cable.
8. Solder all of the hand crimp terminals excepting Micro-Pack 100.64 size. Soldering Micro-Pack 100 World terminals may damage the terminal.
Tyco/AMP Connectors (Sensor)
TYCO/AMP CONNECTORS (SENSOR)
TOOLS REQUIRED
J 38125-D Terminal Repair Kit
TERMINAL REMOVAL PROCEDURE
1. Disconnect the connector from the component.
