Rendezvous FWD V6-3.4L VIN E (2005)
Stabilizer Bushing: Service and Repair
Front Suspension
Stabilizer Shaft Insulator Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tires.
3. Remove the side stabilizer shaft insulator bracket bolts.
4. Use a pry bar in order to remove the stabilizer shaft insulator brackets.
5. Remove the stabilizer shaft insulators (4).
Installation Procedure
1. Install the stabilizer shaft insulator.
2. Ensure that the stabilizer shaft insulator locating tabs (3) align with the indentations in the frame (2).
3. Install the left and right side stabilizer shaft insulator brackets.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the left and right side stabilizer shaft insulator bracket bolts.
Tighten the stabilizer shaft insulator bracket bolts to 48 Nm (35 inch lbs.).
5. Install the front tires.
6. Lower the vehicle.
