Rendezvous FWD V6-3.4L VIN E (2005)
4. Notice:
Refer to Fastener Notice in Service Precautions.
Install the shift indicator fasteners.
Tighten the shift indicator fasteners in the order shown to 2 Nm (18 inch lbs.).
5. Move the shift control through the entire range. If the shift lever contacts either side of the shift indicator, loosen the shift indicator fasteners and
repeat the installation procedure.
6. Connect the shift indicator lamp to the shift indicator and ensure that the shift indicator lamp is functional.
7. Install the center console trim plate.
8. Install the shift control handle.
9. Install the shift control handle retainer.
10. Shift the transaxle into Park.
11. Disengage the park brake and remove the wheel blocks.
