Rendezvous FWD V6-3.4L VIN E (2005)
Transmission Mount: Service and Repair
Automatic Transmission Mount Bracket Replacement
Automatic Transmission Mount Bracket Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the left front tire and wheel.
3. Remove the left engine splash shield.
4. Use a utility stand with a block of wood in order to support the transaxle.
5. Remove the transaxle mount upper nuts.
6. Remove the transaxle mount bracket bolts.
7. Remove the transaxle mount bracket.
Installation Procedure
1. Position the transaxle mount bracket.
2. Notice:
Refer to Fastener Notice in Service Precautions.
Install the transaxle mount bracket bolts.
Start with the forward lower bolt and work clockwise to tighten the transaxle mount bracket bolts to 95 Nm (70 ft. lbs.).
3. Remove the utility stand.
