Rendezvous FWD V6-3.4L VIN E (2005)
6. Disconnect the wheel speed sensor electrical connector (2).
Installation Procedure
1. Connect the wheel speed sensor electrical connector (2).
2. Install the wheel bearing/hub.
3. Caution: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these
fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.
Notice: Refer to Fastener Notice in Service Precautions.
Install NEW wheel bearing/hub bolts.
Tighten the wheel bearing/hub bolts to 85 Nm (63 ft. lbs.).
4. Install the brake drum.
5. Install the tire and wheel.
6. Lower the vehicle.