Rendezvous FWD V6-3.5L VIN L (2006)
7. Remove the rear door body side molding lower support from the door.
Installation Procedure
1. Position the lower support retainer with the notch down and the retainers to the holes in the door panel.
2. Install in the center pins of the retainers using a small hammer.
3. Position the lower edge of the molding to the lower door retainer.
4. Align the door molding retainers to the holes in the door.
5. Press the molding to the door until the retainers are fully seated.
6. Close the rear door.