Rendezvous FWD V6-3.5L VIN L (2006)
Sunroof / Moonroof Track: Service and Repair
SUNROOF TRACK TIMING/SYNCHRONIZATION (PES)
REMOVAL PROCEDURE
1. Remove the headliner.
2. Disconnect the electrical connector from the motor/actuator.
3. Remove the motor/actuator.
4. Remove the screw that attaches the control module.
5. Install a pin temporarily in the holes to hold the position while installing the drive motor.
6. Remove the sunroof window.
7. Manually slide the mechanism forward in the track until the mechanism reaches the hard stop.
8. Push the cam assembly (2) forward until the timing hole (3) in the cam is aligned with the timing hole (4) in the lifter arm (1).
9. Repeat this procedure for the opposite side.
IMPORTANT: Both mechanisms should now be in the closed position.
INSTALLATION PROCEDURE
1. Install the sunroof window.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 4 N.m (35 lb in).
