Rendezvous FWD V6-3.5L VIN L (2006)
1. Install the cruise control release switch (3), if equipped, and the stop lamp switch (1) to the brake pedal with the bracket (2).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the brake pedal brace (4) with the mounting nuts (1) to the bracket.
Tighten the nuts (1) to 10 Nm (89 inch lbs.).
3. Install the brake pedal with the bracket (3).
4. Install the upper mounting bolt for the brake pedal brace (4).
Tighten the bolt to 10 Nm (89 inch lbs.).
5. Install the brake pedal bracket mounting nuts (2).
Tighten the nuts (2) to 25 Nm (18 ft. lbs.).
6. Install the brake booster mounting nuts (3).
Tighten the nuts (3) to 25 Nm (18 ft. lbs.).
7. Install the knee bolster.
8. Connect the electrical connectors to the cruise control release if equipped and stop lamp switch.
9. Install the booster push rod (2) to the brake pedal (1).
10. Adjust the stop lamp switch and the cruise control release switch if equipped.
11. Install the left side insulator panel.
