Rendezvous FWD V6-3.5L VIN L (2006)
3. lubricate the brake caliper bolt shaft. Do not lubricate the threads.
4. lubricate the brake caliper bolt boots (4) in the brake caliper bracket (3).
5. Notice: Refer to Fastener Notice in Service Precautions.
Install the brake caliper bolts.
Tighten the brake caliper bolts to 45 Nm (33 ft. lbs.).
6. Use a flat-bladed tool in order to install the brake caliper bracket boot over the shoulder of the brake caliper bolt.
7. Remove the plugs in the brake hose end.
8. Important: Install NEW copper brake hose gaskets (3).
Assemble the brake hose bolt (1) and the NEW copper brake hose gaskets (3) to the brake hose (2).
9. Install the brake hose bolt to the brake caliper.
10. Remove the nuts securing the rotor to the hub.
11. Install the tire and wheel.
12. Lower the vehicle.
13. Fill the master cylinder to the proper level.
14. Bleed the brake system.
15. Apply approximately 778 Nm (175 ft. lbs.) of force to the brake pedal for ten seconds.
16. Inspect the brake caliper and hydraulic brake system for brake fluid leaks.
