Rendezvous FWD V6-3.5L VIN L (2006)
19. Remove the radiator and condenser assembly.
20. Remove the condenser tube clip bolt.
21. Remove the condenser mounting bolts.
22. Remove the condenser from the radiator.
Installation Procedure
1. Install the condenser to the radiator.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the mounting bolts that secure the condenser to the radiator.
Tighten the bolts to 6 Nm (53 inch lbs.).
3. Install the condenser tube clip bolt.
Tighten the bolt to 2.5 Nm (22 inch lbs.).
4. Install the radiator and condenser assembly.
5. Remove the cap or the tape from the evaporator inlet tube.
6. Install a new seal washer to the evaporator inlet tube.
7. Install the evaporator inlet tube and the bolt to the condenser block.
Tighten bolt to 16 Nm (12 ft. lbs.).
8. Remove the cap or the tape from the A/C discharge hose.
9. Install a new sealing washer to the A/C discharge hose.
10. Install the A/C discharge hose and the nut to the condenser block.
