Rendezvous FWD V6-3.5L VIN L (2006)
Engine Block Heater: Service and Repair
Coolant Heater Cord Replacement (RPO LX9)
Coolant Heater Cord Replacement (RPO LX9)
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the coolant heater cord (1) from the coolant heater.
3. Remove the coolant heater cord clip (2) from the transaxle brace.
4. Cut the tie strap (3) attaching the coolant heater cord to the engine harness.
5. Cut the tie strap (1) attaching the coolant heater cord to the engine harness.