Rendezvous FWD V6-3.5L VIN L (2006)
Important: Align the ball stud cotter pin hole parallel to the knuckle in order to ease the cotter pin installation.
16. Install the ball stud to the knuckle.
17. Install the ball stud nut.
Tighten the nut to 55 Nm (40 ft. lbs.).
Important: Do not loosen the ball stud nut in order to align the ball stud nut slots to the ball stud cotter pin hole.
18. If necessary, tighten the ball stud nut in order to align the ball stud nut slot (1) to the ball stud cotter pin hole (2) as shown.
Important: Ensure that the cotter pin ends do not contact the ABS sensor connector or the drive axle.
19. Install a NEW cotter pin and bend the ends as shown in either direction.
20. Install the engine harness clips for the wheel speed sensor to the right lower control arm.
