Rendezvous FWD V6-3.5L VIN L (2006)
34. Remove the MAP sensor bolt.
35. Remove the MAP sensor bracket and sensor.
36. Remove and inspect the throttle body seal, replace as necessary.
Installation Procedure
1. If the intake manifold was replaced perform the following steps, if not proceed to step 10.
2. Install the MAP sensor seal.
3. Install the MAP sensor bracket and sensor.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the MAP sensor bolt.
Tighten the bolt to 10 Nm (89 inch lbs.).
