Rendezvous FWD V6-3.5L VIN L (2006)
Air Door Actuator / Motor: Service and Repair
Mode Actuator Replacement
MODE ACTUATOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the knee bolster from the instrument panel (I/P).
2. Disconnect the mode actuator electrical connector.
3. Open the mode actuator push rod retainer clip (1) with a small flat-bladed screwdriver.
IMPORTANT: Count the number of threads showing from the tip of the mode actuator push rod to the end of the retainer clip.
4. Disconnect the mode actuator push rod (2) from the retainer clip (1).
5. Disconnect the I/P wiring harness clip from the I/P support bracket.
IMPORTANT: Disconnect the I/P wiring harness clip from the I/P support bracket to help access the mode actuator screws.
6. Remove the mode actuator mounting screws.
7. Remove the mode door actuator.
INSTALLATION PROCEDURE
1. Install the mode actuator.
2. Install the mode actuator mounting screws.
Tighten the screws to 1.6 N.m (14 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the I/P wiring harness clip to the I/P support bracket.