Rendezvous FWD V6-3.5L VIN L (2006)
Control Module HVAC: Service and Repair
BLOWER MOTOR CONTROL PROCESSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the right side I/P insulator.
2. Disconnect the blower motor electrical connector.
3. Remove the blower motor mounting screws.
4. Remove the blower motor from the HVAC module assembly.
5. Disconnect the electrical connector from the blower motor control processor assembly.
6. Remove the forward blower control processor mounting screws.
7. Remove the rearward blower control processor mounting screw.
8. Remove the blower control processor assembly from the HVAC module assembly.
INSTALLATION PROCEDURE
1. Install the blower motor control processor assembly to the HVAC module assembly.
2. Install the rearward mounting screw.
Tighten the screw to 1.8 N.m (16 lb in).
