buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

Deployment Inside Vehicle - Vehicle Scrapping Procedure|Page 13885 > < Deployment Inside Vehicle - Vehicle Scrapping Procedure|Page 13883
Page 1
background image

Air Bag: Service and Repair
Inflatable Restraint Side Impact Module Replacement - Right

INFLATABLE RESTRAINT SIDE IMPACT MODULE REPLACEMENT - RH

REMOVAL PROCEDURE

1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 9.

CAUTION:  
-

Refer to SIR Inflator Module Handling and Storage Caution in Service Precautions.

-

Refer to SIR Caution in Service Precautions.

2. Remove the passenger seat. 
3. Remove the J-clip from the lower rear seat back.
4. Remove the seat back cover. 

5. Remove the air bag fasteners (1).
6. Note the routing of the air bag wiring harness (3) and the retaining clip attachments within the passenger seat.
7. Remove the retaining clips on the air bag wiring harness from the passenger seat frame.
8. Gently pull the air bag wiring harness (3) up into the seat back while guiding the harness through the wire triangle of the seat frame.
9. Remove the air bag (2) from the seat back frame.

10. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required

retention period. Refer to Inflator Module Handling and Scrapping.

CAUTION:  
-

Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:
-

The seat cushion frame

-

The seat recliner, if equipped

-

The seat adjuster

-

The seat back frame

-

Failure to do so may cause future personal injury.

INSTALLATION PROCEDURE

1. Install the passenger side air bag (2) to the seat while guiding the air bag wiring harness (3) through the trim cup.
2. Install the air bag fasteners (1).

Tighten the fasteners (1) to 10 N.m (89 lb in).

NOTE:  Refer to Fastener Notice in Service Precautions.

3. Gently pull the air bag wiring harness (3) down into the seat cushion while guiding the harness through the wire triangle of the seat frame.
4. Install the harness retaining clips to the seat frame.
5. Install the seat back cover. 
6. Connect together the J-clip that is along the lower rear seat back.

Deployment Inside Vehicle - Vehicle Scrapping Procedure|Page 13885 > < Deployment Inside Vehicle - Vehicle Scrapping Procedure|Page 13883