Rendezvous FWD V6-3.5L VIN L (2006)
5. Connect the steering wheel module coil connector (1).
6. Install the CPA to the steering wheel module coil connector (1) located at the base of the steering column.
7. Install the LH insulator panel.
8. Connect the I/P module connector (1).
9. Install the CPA (2) to the I/P module connector (1).
10. Install the RH insulator panel.
11. Connect the right SIS and pretensioner harness connectors (4).
12. Install the CPA (2) to the SIS and pretensioner harness connectors (4).
13. Connect the vehicle harness connector to the RF side impact module connector (1).
14. Install the CPA to the RF side impact module yellow connector (1).
15. Install the SIR Fuse.
16. Install the console accessory wiring junction block access hole cover.
