Rendezvous FWD V6-3.5L VIN L (2006)
Refrigerant Pressure Sensor / Switch: Service and Repair
AIR CONDITIONING (A/C) REFRIGERANT PRESSURE SENSOR REPLACEMENT
TOOLS REQUIRED
J 39400-A Halogen Leak Detector
REMOVAL PROCEDURE
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the air baffle bolts.
3. Remove the air baffle.
4. Disconnect the A/C refrigerant pressure sensor electrical connector.
5. Remove the A/C refrigerant pressure sensor from the evaporator inlet tube.
INSTALLATION PROCEDURE
1. Using a lint-free clean, dry cloth, carefully clean the sealing surfaces of the evaporator inlet tube fitting.
2. Lightly coat the O-ring seal with mineral base 525 viscosity refrigerant oil.
IMPORTANT: DO NOT allow any of the mineral base 525 viscosity refrigerant oil on the O-ring seal to enter the refrigerant system.
3. Install the A/C refrigerant pressure sensor to the evaporator inlet tube.
Tighten the sensor to 5 N.m (44 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
4. Connect the A/C refrigerant pressure sensor electrical connector.
5. Leak test the fittings of the component using J 39400-A.