Rendezvous FWD V6-3.5L VIN L (2006)
Stabilizer Link: Service and Repair
Front Suspension
Stabilizer Shaft Link Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Remove the stabilizer shaft link bolt and nut.
3. Use a pry bar in order to remove the stabilizer shaft link insulators and the spacer.
Installation Procedure
1. Use a pry bar in order to install the stabilizer shaft link insulators and the spacer.
2. Install the stabilizer shaft link and insulators.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the stabilizer shaft link bolt and nut.
^
Tighten the stabilizer shaft link nut to 18 Nm (13 ft. lbs.).
4. Lower the vehicle.