Rendezvous FWD V6-3.5L VIN L (2006)
Important: Ensure the trilobal tripot bushing is flush with the face of the housing.
7. Place approximately 1/2 of the grease from the service kit in the wheel drive shaft inboard seal. Use the remainder of the grease to repack the
housing.
8. Install the trilobal tripot bushing (3) to the housing (1).
9. Position the larger new seal retaining clamp (2) on the wheel drive shaft inboard seal.
10. Slide the housing over the tripot joint spider assembly on the wheel drive shaft bar.
11. Slide the large diameter of the wheel drive shaft inboard seal (2), with the large clamp (3) in place, over the outside of the trilobal tripot bushing
and locate the lip of the seal in the groove.
Important: The seal must not be dimpled, stretched or otherwise deformed.
