Rendezvous FWD V6-3.5L VIN L (2006)
Liftgate Window Glass: Service and Repair
Window Replacement - Liftgate (Buick)
Tools Required
*
J 24402-A Glass Sealant Remover
*
J 39032 Stationary Glass Removal Tool
*
Urethane Adhesive Kit GM P/N 12346392 or Equivalent
*
Isopropyl Alcohol
*
Cartridge-type Caulking Gun
*
Commercial-type Utility Knife
*
Razor Blade Scraper
*
Suction Cups
*
Plastic Paddle
Removal Procedure
Caution: Refer to Cracked Window Caution in Cautions and Notices.
Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces
and the interior trim.
1. Remove the rear wiper motor. Refer to Wiper Motor Replacement - Rear in Wipers/Washer Systems.
2. Remove the center light applique.
3. Disconnect the rear liftgate window defogger connectors from the right and the left sides.
4. Tape off and protect the inner edges of the rear window defogger grid lines from the window removal tool.
Caution: Refer to Glass and Sheet Metal Handling Caution in Cautions and Notices.
Important: Keep the cutting edge of the tool against the window. Inspect the depth of the cutting blade before starting.
5. Separate the urethane adhesive from the window:
*
Leave a base of urethane on the pinchweld flange.
*
The only suitable lubrication is clear water.
*
Use J 24402-A , J 39032 or equivalent in order to remove the window.