Riviera V6-231 3.8L Turbo VIN 8 4-bbl (1983)
FIGURE 2 - SECTION A-A - FRONT DOOR UPPER TRIM PANEL REMOVAL
6.
Using tool shown in Figure 1, insert tip of tool behind trim pad rear retaining embossment as shown in Figure 2. Rotate tool inboard to disengage
pad from rear retainer.
7.
Repeat Step #6 at front retaining embossment.
INSTALLATION
1.
Before installing door trim, check that all trim retainers are securely installed to trim assembly and are not damaged. Replace damaged trim
retainers as required.
2.
Check door belt trim support retainers to determine if they are broken. If retainer(s) is broken, use belt trim support retainer plate (Part No.
20433097) to repair door belt trim support. Retainer plate should be secured to the door trim assembly by drilling two (2) holes through plate and
belt trim support and securing plate to support with pop-rivets as shown in view "A", Figure 2.
The belt trim support retainer plate is available as a service part and may be used to repair any door trim pad that is of similar design.
