Roadmaster V8-305 5.0L (1992)
Weatherstrip: All Technical Service Bulletins
Wind Noise At Rear Door Glass
Figure 5
CAUTION:
APPROVED SAFETY GLASSES AND GLOVES SHOULD BE WORN WHEN PERFORMING THIS PROCEDURE TO REDUCE THE CHANCE
OF PERSONAL INJURY.
X.
Wind noise at rear door stationary glass seal to door frame.
1.
Remove the rear door stationary glass per Section 10 of the Service Manual.
2.
Starting at the top of the division post and continuing rearward to the bottom of the stationary glass opening, apply a bead of bedding and glazing
compound to the inboard edge of the retainer.
3.
Fill the two cavities at the lower corner of the stationary glass channel with strip caulk sealer.
4.
Reinstall stationary glass.
NOTE:
When reinstalling stationary glass, care should be taken to ensure that the stationary glass seal is parallel with the belt line molding. The seal flap around
the perimeter of the stationary glass must be outboard of the reveal molding.
WARRANTY INFORMATION:
Labor Operation:
C0400 Right C0401 Left
Labor Time:
1.0 Hr. Per Door
