Roadmaster V8-305 5.0L (1992)
Compressor Clutch Hub: Service and Repair
4 POLE AND 6 POLE CLUTCH
Remove or Disconnect
1. If compressor is on the vehicle, loosen compressor mounting brackets, disconnect the compressor drive belt and reposition the compressor for
access, if necessary.
If compressor has been removed from the vehicle, attach the compressor to Holding Fixture 3 25008-A and clamp the Holding Fixture in a vise
(Fig. 5).
^
Compressor mounting holes are metric. Use proper metric bolts with holding fixture J 25008-A.
2. Keep the clutch hub from turning with the Clutch Hub Holding Tool J 33027-A, remove the shaft nut, using Thin Wall Socket J 9399 (Fig. 5).
3. Thread the Clutch Plate and Hub Assembly Remover J 33013-B, into the hub. Hold the body of the Remover with a wrench and turn the center
screw into the Remover body to remove the Clutch Plate and Hub assembly (Fig. 6).
4. Remove the shaft key.
Install or Connect