Roadmaster V8-305 5.0L (1992)
Suspension Spring ( Coil / Leaf ): Customer Interest
Suspension - Side to Side Front Trim Height Imbalance
Bulletin: 92-3-20
Date: Oct. '92
Ref.No.: 92-285-3
Corp.Ref.No.: 233306
SUBJECT:
BALANCED FRONT TRIM HEIGHT (DIAGNOSE/REPLACE FRONT SPRING)
MODELS AFFECTED:
1992 BUICK ROADMASTER SEDANS
CONDITION:
Some 1992 Buick Roadmaster Sedans with base suspension systems, RPO FE1, may exhibit what appears to be a side to side trim height imbalance as
viewed from the front of the vehicle. Typically this condition would appear as if the right front corner of the vehicle is lower than the left front corner.
CAUSE:
Front spring selection is based on the vehicle mass as seen by the front wheels and a common spring is selected for both front corners of the vehicle,
independent of the side to side mass differential.
CORRECTION:
Following procedure indicated below, measure the "A" dimension shown in illustration for both sides of vehicle to determine if spring replacement is
required.
SERVICE PROCEDURE:
1.
Perform the following checks and make sure:
^
Tires are at the correct pressure as shown on the Tire Placard "up to vehicle capacity."
^
Fuel tank is full.
^
Vehicle has no additional weight or passengers.
^
Front seat is in rear position.
^
Trunk is empty except for the spare tire and jack, and simulated fuel load if required.
^
Vehicle is on a known level floor.
^
All doors, hood and rear compartment lid are closed.
2.
Lift front bumper of vehicle up approximately 38 mm (1-1/2 inch). Gently remove hands and let vehicle settle.
^
Repeat operation for a total of two (2) times.
^
After the second time, measure "A" dimension.
3.
Push front bumper down approximately 38 mm (1-1/2 inch). Gently remove hands and let vehicle rise on its own.
^
Repeat operation for a total of two (2) times.
^
Measure "A" dimension.
4.
Calculate the average of the two "A" dimensions measured for each side of the vehicle.
5.
If the difference between the "A" dimension averages side to side are:
