Roadmaster V8-350 5.7L VIN P MFI (1995)
Throttle Position Sensor: Service and Repair
Throttle Position Sensor
REMOVE OR DISCONNECT
1. Resonator.
2. Throttle Position Sensor (TPS) sensor electrical connector.
3. Remove two TP sensor attaching screws.
4. TP sensor.
NOTICE: The TP sensor is an electrical component and must NOT be soaked in any liquid cleaner or solvent as damage may result.
INSTALL OR CONNECT
1. With the throttle valve in the normally closed idle position, install throttle position sensor on throttle body assembly, making sure TP sensor lever
lines up with the TP sensor drive lever on the throttle shaft.
2. TP sensor screws.
Tighten
^
TP sensor screws to 2.0 Nm (18.0 lb in.).
3. TP Electrical connector.
4. Resonator.
