Roadmaster V8-350 5.7L VIN P MFI (1995)
Refer to figures shown in this bulletin.
SHIFT LINKAGE ADJUSTMENT
NOTE:
The shift linkage must be adjusted each time the transmission is replaced.
1.
Place vehicle on hoist. Place the steering column range selector in the "N" (neutral) position.
IMPORTANT:
THE VEHICLE MUST BE AT THE CORRECT TRIM HEIGHT FOR PROPER LINKAGE ADJUSTMENT. VEHICLE MUST BE SUPPORTED
BY ALL FOUR (4) TIRES OR BY JACK STANDS ON THE REAR AXLE TUBE SUCH THAT THE SUSPENSION IS AT THE PROPER TRIM
HEIGHT.
2.
Loosen screw, automatic transmission range selector rod swivel (816).
Note:
Ensure rod assembly, automatic transmission range selector (820) will move freely in swivel, automatic transmission range selector rod (818).
Tapping on assembly with hammer may help free the rod and swivel assembly.
3.
Hang a weight (approximately three (3) pounds or 1.4 kilograms) on the end of the steering column selector lever to bias the selector lever towards
but not into the "OD" (overdrive) position.
Note:
Kent Moore tool number "J8092", drive handle, weighs approximately three (3) pounds, may be a possible choice.
4.
Verify that the transmission is in the "NEUTRAL" position.
5.
Tighten screw, automatic transmission range selector rod swivel, (816) to 28 N.m (21 lb. ft.).
