Roadmaster Estate Wagon V8-305 5.0L (1991)
Valve Body: Service and Repair
Valve Body Removal
1.
Remove transmission oil pan and filter.
2.
Remove screw and washer securing T.V. cable to the transmission.
3.
Disconnect electrical connectors.
4.
Remove bolts securing the electrical connector clips.
5.
Remove bolts securing the solenoid assembly, then solenoid with O-ring.
6.
Disconnect case electrical connector, then remove O-ring seal.
7.
If equipped, remove temperature switch and attaching bolt.
8.
Remove pressure switch, then the T.V. lever and bracket assembly, from cable link.
9.
Remove T.V. lever bracket assembly, then manual detent roller and spring assembly.
10.
Remove the signal oil pipe retainer and signal pipe.
11.
Support the control valve assembly, then remove the remaining valve body bolts and control valve assembly. Care must be taken when
removing the control valve assembly to prevent loss of three check balls located in the assembly. Do Not carry assembly by attached pipe.
12.
Remove the check balls.
13.
Lay control valve assembly down with the sensor plate side up. Do not damage the switches.
14.
Reverse procedure to install. Torque valve body bolts to 11 ft. lbs.
