Roadmaster Estate Wagon V8-350 5.7L VIN P SFI (1996)
Cruise Control Servo Cable: Service and Repair
Fig. 30 Cruise Control Cable Retainer Removal.
Fig. 31 Cruise Control Cable Removal
The cable is connected between the cruise control module and throttle body lever.
1. Remove air cleaner and resonator.
2. Remove cable and conduit from engine bracket, Fig. 30.
3. Remove cable end fitting from throttle body lever stud.
4. Remove cruise control retainer at module.
5. Remove cable from module as follows:
a. Compress conduit tangs, Fig. 31, and pull out of module housing.
b. Disconnect cable bead from cruise motor band end fitting on module, Fig. 31.
c. Note routing and remove cable.
6. Reverse procedure to install noting the following:
