Roadmaster Estate Wagon V8-350 5.7L VIN P SFI (1996)
1. Setup.
^
Ensure battery is charged
^
Turn ignition "ON"
^
Ensure connections to the Data Link Connector (DLC).
2. Program the PCM using the latest software matching the vehicle. Refer to Techline terminal/equipment users instructions.
3. If the PCM fails to program. proceed as follows:
^
Ensure that all PCM connections are OK.
^
Check the Tech line terminal/equipment for the latest software version.
^
Attempt to program the PCM. If the PCM still cannot be programmed properly, replace the PCM. The replacement PCM must be
programmed.
FUNCTIONAL CHECK
1. Perform On-Board Diagnostic System Check.
2. Start engine and run for one minute.
3. Scan for DTCs using the scan tool.
4. If DTC P0325 sets, the KS module is not fully seated, is missing, or is faulty.