Roadmaster Estate Wagon V8-350 5.7L VIN P SFI (1996)
INSTALLATION PROCEDURE
1. Lubricate the new crossover tube O-rings (1) with clean engine oil.
2. Install the O-rings (1) on the crossover tube (2).
3. Install the crossover tube (2) into the fuel rail sections.
4. Install the crossover tube retainers (3) and the attaching screws (4).
Tighten
Screws to 5 Nm (44 lb. in).
5. Install the fuel tube bracket and the attaching screw.
Tighten
Screws to 5 Nm (44 lb. in).
6. Install the fuel rail assembly.
7. Tighten the fuel filler cap.
8. Connect the negative battery cable.
9. Inspect for leaks.
A. Turn the ignition switch ON for 2 seconds.
B. Turn the ignition switch OFF for 10 seconds.
C. Turn the ignition switch ON.
D. Check for fuel leaks.
