Roadmaster Estate Wagon V8-350 5.7L VIN P SFI (1996)
2. Rear ends of fuel feed and return pipes into top forward frame hole.
3. Raise vehicle.
4. Route pipes in same position as noted during disassembly.
5. Quick-connect fittings at fuel sender assembly.
6. Fuel feed, return, and EVAP pipe underbody retainer.
7. Lower fuel tank shields and tank shield attaching screws.
Tighten
Lower fuel tank shield screws to 1 Nm (9 lb in.).
8. Quick-connect fittings at fuel filter.
9. Close all retaining clips.
10. Lower vehicle.
11. Fuel feed and return pipe retaining clip at brake booster.
12. Quick-connect fittings at fuel rail in engine compartment.
13. Negative battery cable.
INSPECT
^
Turn ignition switch to "ON" position for two seconds, then turn to "OFF" for ten seconds. Again turn to "ON" position and check for fuel leaks.
