Roadmaster Estate Wagon V8-350 5.7L VIN P SFI (1996)
^
Gasket sealing surfaces.
NOTICE: Use care in cleaning old gasket material from machined aluminum surfaces as sharp tools may damage sealing surfaces.
INSTALL OR CONNECT
1. Throttle body assembly with new flange gasket.
2. Throttle body attaching bolts
Tighten
Bolts to 15 Nm (11 lb ft.).
3. Accelerator control cable and cruise control cable.
4. Coolant hoses to throttle body.
5. Vacuum lines to throttle body.
6. Electrical connectors to TP sensor and IAC valve.
5. Distributor ventilation line at the air intake duct.
4. Electrical connectors from IAT sensor.
3. Resonator.
8. Refill cooling system.
9. Connect negative battery cable
10. Ensure accelerator pedal is free.
11. Reset IAC valve position:
A. Depress accelerator pedal slightly.
B. Start engine.
C. Release accelerator pedal.
D. Run engine for 5 seconds.
E. Turn ignition "OFF" for 10 seconds.
F. Restart engine.
G Check for proper idle operation.
