Roadmaster Estate Wagon V8-350 5.7L VIN P SFI (1996)
Replace knuckle and lower ball stud following applicable Service Manual Procedure, Section 3C-3, Front suspension. Check and adjust wheel
alignment and toe-in after new knuckle and lower ball stud is installed. Proceed to Step 10.
OR
GAP: (Ball stud IS seated in knuckle)
Tighten nut and torque to between 95 Nm (70 lb. ft.) to 112 Nm (83 lb. ft.), then tighten nut enough to align slot in nut with hole in ball stud and
install new cotter pin. Nut rotation to align cotter pin hole is not to exceed one flat (60 degrees).
9.
Lower vehicle.
10.
Install Campaign Identification Label.
