Skyhawk L4-112 1.8L VIN 0 TBI (1982)
Turn Signal Switch: Service and Repair
Fig. 6 Compressing lock plate
1.
Disconnect battery ground cable.
2.
Remove steering wheel as outlined under ``Steering Wheel, Replace'' procedure.
3.
Using a suitable screwdriver, pry cover from housing.
4.
Using lock plate compressing tool J-23653-4, compress lock plate and pry snap ring from groove on steering shaft, Fig. 6. Slowly release
compressing tool, then remove tool and lock plate from shaft.
5.
Slide canceling cam and bearing preload spring from steering shaft.
6.
Remove turn signal (multi-function) lever.
7.
Remove hazard warning knob retaining screw, button, spring and knob.
8.
Remove actuator arm screw and actuator arm.
9.
Remove switch retaining screws and pull switch upward from column, guiding wire harness through column.
10.
Reverse procedure to install.
