Skyhawk L4-112 1.8L VIN 0 TBI (1982)
Timing Belt: Recalls
Part II - Timing Belt R&R Procedure
REMOVAL
1.
Loosen generator pivot bolts.
2.
Remove power steering belt (if equipped).
3.
Remove two (2) upper timing cover bolts.
4.
Disconnect canister purge hose and swing aside.
5.
Hoist vehicle.
6.
Remove right front wheel.
7.
Remove inner splash shield.
8.
Remove two (2) lower timing cover bolts; leave cover on.
9.
Remove air conditioning belt (if equipped).
10.
Remove crankshaft pulley.
11.
Lower vehicle to just above floor.
12.
Remove lower timing cover.
13.
Remove coolant reservoir.
14.
Remove probe holder.
15.
Align timing mark on camshaft gear with mark on camshaft carrier.
Important:
Do not turn camshaft. Use only crankshaft nut to turn. Turning the nut on the camshaft directly can damage the camshaft
bearings..
16.
Loosen water pump bolts and remove timing belt (with timing marks aligned).
FIGURE 1
