Skyhawk L4-112 1.8L VIN 0 TBI (1982)
Wheel Hub: Service and Repair
REAR HUB/BEARING
1.
Raise and support vehicle, then remove wheel and tire assembly and brake drum. Do not hammer brake drum since damage to bearing may
result.
2.
Remove four hub/bearing assembly to rear axle attaching bolts, then the hub/bearing assembly from axle. The upper rear hub attaching bolt
may not clear brake shoe when removing hub and bearing assembly. Partially remove hub and bearing assembly prior to removing this
bolt.
3.
Reverse procedure to install. Torque hub to axle attaching bolts to 37 ft. lbs. Use care not to drop hub/bearing assembly since damage to
bearing may result.
