Skyhawk L4-121 2.0L (1986)
Water Pump: Service and Repair
Overhead Cam
1.
Drain cooling system, then remove timing belt. Refer to ``Timing Belt, Replace'' for procedure.
2.
Remove timing belt rear protective covers, as required.
3.
Remove lower radiator hose from water pump.
4.
Remove water pump attaching bolts then the water pump and sealing ring.
5.
Clean engine block and water pump sealing surfaces, then apply a 3/32 inch of RTV sealant to sealing surfaces. While RTV sealant is still wet,
install water pump. Tighten attaching bolts finger tight.
6.
Install lower radiator hose on water pump, then timing belt rear protective covers.
7.
Install timing belt. Refer to ``Timing Belt, Replace'' for procedure.
