Skyhawk L4-121 2.0L Turbo VIN M FI (1987)
FIGURE 2
COIL WIRE SHIELD ONLY REQUIRED
3.
Remove upper existing coil bolt.
4.
Loosen lower existing coil bolts.
5.
Install shield (See Figure 2).
6.
Reinstall existing upper coil bolt and hand tighten.
7.
Hand tighten lower coil bolts.
8.
With shield in position, ensure at least 2 mm clearance to the distributor cap (Figure 2, View A). Bend engine lift bracket if required for minimum
clearance. SHIELD MUST NOT CONTACT DISTRIBUTOR CAP.
9.
Torque upper and lower coil bolts 20-30 N-m (15-22 ft.lbs.).
10.
Connect electrical wiring at coil. COIL WIRE NIPPLE MUST NOT CONTACT SHIELD.
11.
Install air cleaner.
12.
Connect negative battery cable.