Skyhawk L4-121 2.0L VIN 1 TBI (1988)
Fuel Injector: Service and Repair
Fuel Injector Removal View
Removal Of TBI Fuel Injector
REMOVAL
1.
Relieve fuel pressure. See MAINTENANCE PROCEDURES.
2.
Disconnect battery ground cable, then remove air cleaner assembly.
3.
Disconnect electrical connector at fuel injector.
4.
Remove fuel injector retainer screw and retainer.
5.
Using a smooth object as a fulcrum, place screwdriver blade under ridge opposite electrical connector end of fuel injector and carefully pry it out.
6.
Remove and discard O-rings.
Fuel Injector Part Codes
INSTALLATION
1.
Lubricate replacement O-rings with clean engine oil, then install upper and lower O-rings ensuring that upper O-ring is in groove and the lower
one is up flush against the filter.
