Skylark L4-138 2.3L DOHC VIN D MFI QUAD 4 (1989)
1.
Start engine and operate vehicle for a minimum of 15 miles (24 km).
2.
Park vehicle on level ground.
3.
Move gear selector to "Park" (P).
4.
Apply parking brake and block wheels.
5.
Let vehicle idle for 3 minutes with accessories turned off.
6.
Check fluid level, color and condition.
AUTOMATIC TRANSMISSION FLUID - REAR WHEEL DRIVE
Transmission Fluid Information
When adding or changing fluid, use only DEXRON II. Refer to MAINTENANCE AND LUBRICATION (SEC. 0B) of the Service Manual for
maintenance information and servicing intervals.
NOTICE:
Do not overfill. Overfilling will cause foaming, loss of fluid and possible damage to the transmission.
^
Fluid level should be checked when it reaches normal operating temperatures of 88-93C (190-200F). This temperature is reached after
approximately 15 miles (24 km) of highway driving.
^
Fluid color will be red when new.
IMPORTANT:
When new, automatic transmission fluid is red in color. The dye is to distinguish it from engine oil or antifreeze. The red dye is not an indicator of fluid
quality and is not permanent. As the vehicle is driven, the transmission fluid will begin to look darker in color. The color may eventually appear light
brown.
^
Inaccurate fluid level readings will result if the fluid is checked immediately after the vehicle has been operated:
-
In high ambient temeperatures above 32 C (90 F)
-
At sustained high speeds
-
In heavy city traffic during hot weather
-
As a towing vehicle.
-
In commercial service (taxi or police use).
Transmission Fluid Checking Procedure
1.
Start engine and operate vehicle for a minimum of 15 miles (24 km).
2.
Park vehicle on level ground.
3.
Move gear selector to "PARK".
4.
Apply parking brake and block wheels.
5.
Let vehicle idle for 3 minutes with accessories off.
6.
Check fluid level, color and condition.
MANUAL TRANSAXLES - FRONT WHEEL DRIVE
Check the fluid level with the engine not running, vehicle level, and the transaxle cool enough so that you can rest your fingers on the transaxle case.
Remove the fluid level indicator.
If within specification, do not add additional fluid. Fluid may appear on the bottom of the indicator, even when the fluid is several pints low. To ensure
accurate reading, remove the level indicator, wipe it clean, reinsert it and remove to read the level. If below specification, add sufficient fluid to bring
within specification.
HYDRAULIC CLUTCH FLUID
Some vehicles equipped with manual transaxles utilize a hydraulic clutch assembly. Check the fluid level with the vehicle level and the clutch reservoir
cap removed. The fluid should be level with a step in the reservoir housing. If the fluid is below the step, add sufficient fluid to bring the fluid up to the
step.
Hydraulic Clutch Fluid Requirements
GM Part Number 1052535, GM Delco Supreme No. 11 Brake Fluid or GM Part Number 12345347 Hydraulic Clutch fluid, or an equivalent fluid that
meets DOT-3 specifications.
NOTICE:
